Manufacturers > Eclipse > Other Burners & Accessories
Click on an item for information

Industrial Gas Burners & Accessories

Eclipse
   
Click logo for manufacture site
Line Burners
Eclipse Industrial Line Burners
 

Eclipse Line Burners are premix, retention type burners designed for applications where heat must be distributed over a large area. They are especially suited for oven, kettle, and either recirculating or non-recirculating air heating applications. Capacities range from 19,000 to 335,000 BTU/hr per lineal foot (based on 70% of required air in premix) depending upon the mixture pressure used. Eclipse Line Burners are available in 6" and 12" straight sections; side and bottom inlet straight sections; bottom inlet crosses and tees; and 6" 90 degree elbows.

Links:

Industrial Furnace Gas Burners

Open Burner Nozzles
Eclipse Sticktite Ferrofix Burner Nozzles
 

Eclipse Sticktite and Ferrofix nozzles can be used wherever an open-type nozzle is applicable. Combustion chambers must have balanced or negative pressure. Typical applications include boiler conversion, kilns, ovens, air heaters, furnaces, immersion heating and other applications where the slight excess air introduced into the combustion chamber around the burner is acceptable. All Eclipse Open Burner Nozzles are flame retention type nozzles which ensure satisfactory operation over a wide range of mixture pressures and draft conditions.

Links:

Industrial Furnace Gas Burners

Blast Tips
Eclipse Industrial Burner Blast Tips
 

Blast Tips are small burners designed to handle combustible mixtures of gas and air under sufficient pressure to cause a blast-like flame. In general, Blast Tips are built to burn without the use of any refractory tunnel and are either self-piloting or built to prevent the flame from blowing away under normal conditions of operation. Blast Tips are suitable for a variety of applications. They can be used in groups to heat a wide area

Links:

Industrial Furnace Gas Burners

Various Pilot Types
Eclipse Aluminum Heat Exchanger
 

There is an Eclipse gas pilot available for use with virtually any type of industrial burner. Complete pilot assemblies are available in atmospheric types for either low (4" w.c. to 3 psig) or high (3 psig and above) pressure gas. Ignition methods are either manual or electric.

Links:

Industrial Furnace Gas Burners